LogoLogo
⌘Ctrlk
Service Desk
  • NEON Starting Guide
GitBook Assistant
GitBook Assistant
GitBook Assistant
Good afternoon

I'm here to help you with the docs.

⌘Ctrli
AI Based on your context
LogoLogo
  • Introduction
  • LoRa & LoRaWAN
    • Box Content
    • Installation
    • Provisioning
    • Communication Protocol
    • Measurements & Messages
    • Schedules
    • Data Visualization
    • Online Configurator
    • Configure a Device
    • Default Configurations
    • General
    • Pressure Gauge (PG)
    • Pressure Sensor (PS)
    • Temperature Sensor (TS)
    • Temperature Transmitter (TT)
    • Vibration Sensor (VB)
      • Communication Protocol v2 & v3
      • Communication Protocol v4
        • How to Get Started with the New Features of the NEON Vibration Sensor v4
        • How to use the automatic fault detection
        • How to obtain the FFT data
      • Communication Protocol v4.1
      • How to configure the frequency of measurements and messages
      • How to replace the sensor or probe
      • How to debug a not connected sensor
      • How to debug a not paired sensor
      • How to enable Hanning Window
    • Available Regions
    • LoRaWAN Region
    • Hazardous Locations
    • Device Maintenance
    • Support & Troubleshooting
    • FAQs
Powered by GitBook
For the complete documentation index, see llms.txt. This page is also available as Markdown.
  1. NEON Starting Guide
  2. How-to
  3. Vibration Sensor (VB)

Communication Protocol v4

How to Get Started with the New Features of the NEON Vibration Sensor v4How to use the automatic fault detectionHow to obtain the FFT data
PreviousHow to configure event triggersNextHow to Get Started with the New Features of the NEON Vibration Sensor v4

Was this helpful?

Was this helpful?